RAD Data comm HCD-E1 Specifiche Pagina 77
- Pagina / 150
- Indice
- RISOLUZIONE PROBLEMI
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
LRS-24 Installation and Operation Manual Chapter 4 Management via the CM-2 Module
Supervision Terminal Operating Instructions 4-13
Table 4-2. Terminal Command Set Index for CM-2 Module (Cont.)
Command Function/Action
DSP VER Displays modem versions
DEF RST Defines reset
DEF PWD Define password
HLP Displays list of commands supported by CM-2 module
4.4 Supervision Terminal Operating Instructions
General
This section provides procedures for using a supervision terminal to perform the
following activities:
• Preliminary configuration of the CM-2 module
• Preliminary configuration of I/O modules with internal SNMP agent
• Management of individual modules.
Before starting, make sure you are familiar with the configuration parameters and
management procedures of the CM-2 module, and of each module type installed
in LRS-24.
The procedures given in this section assume that no management station is actively
managing LRS-24. However, the same procedures also apply when the
management station relinquishes control to the supervision terminal.
Refer to the section Transferring Control to the Supervision Terminal below for an
explanation of the procedures used to transfer control from the management
station to the supervision terminal.
Configuring the Terminal
➤ To configure terminal for communication parameters used by the CM-2
Management RS-232 port:
1. Select the full-duplex mode and turn off the terminal echo.
The required communication parameters are 38.4 kbps, 1 start bit,
eight data bits, no parity, 1 stop bit, and no flow control.
2. Connect the supervision cable of the terminal to the MANAGEMENT RS-232
connector of the CM-2 module (refer to Section 4-2 for details).
3. Make sure LRS-24 is powered-up, and then turn on the supervision terminal.
When applicable, also turn on the modems and any other communication
equipment used to connect the terminal to LRS-24.
4. Start the configuration session.
5. Enter password.
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com
- Version 3.00 1
- Warranty 3
- Safety Warnings 4
- Telecommunication Safety 4
- Regulatory Information 5
- Declaration of Conformity 6
- Quick Start Guide 7
- 2. LRS-24 with CM-2 Module 8
- Contents 9
- Table of Contents 10
- List of Figures 11
- List of Tables 12
- Chapter 1 13
- Introduction 13
- Management/CM-2 functions 14
- Versions 15
- Application 15
- Features 16
- Overview 1-5 17
- 1.2 Physical Description 18
- Rear View 19
- Front View 19
- LRS-24B Rear Section 20
- LRS-24 Front Section 20
- LRS-24F ETSI UNIT 21
- LRS-24F Enclosure 21
- LRS-24 Module Slots 22
- 1.3 Functional Description 23
- Common Logic Modules 24
- Management 25
- 1.4 Technical Specifications 26
- External Clock Interface 27
- CM-1 Management Interface 27
- CM-2 Management Interface 27
- Physical Data 28
- Environment 28
- Chapter 2 29
- Installation and Setup 29
- 2-2 Introduction 30
- LRS-24B FRONT VIEW 31
- WITHOUT MODULES 31
- LRS-24B TOP VIEW 31
- LRS-24B SIDE VIEW 31
- AC Power 32
- DC Power 32
- Grounding 32
- 2.3 Unpacking the Chassis 33
- 2.4 Installation and Setup 34
- Installation and Setup 2-7 35
- CM-1 Module 36
- Installation and Setup 2-9 37
- Internal Jumpers 38
- Installation and Setup 2-11 39
- CM-2 Module 40
- 2-14 Installation and Setup 42
- CM-2 Installation 43
- PS Interface Modules 44
- LRSI-F-CM1 45
- Interface Module Installation 46
- LED Color Indication 47
- LINK Link Connection is made 47
- Connect Minor 48
- Alarm Relay 48
- LRSI-F-1-CM2 Installation 49
- LRSI-F-2-CM2 10B2 Front Panel 49
- LRSI-F-2-CM2 50
- LRS-24 Enclosure 52
- AC Power Connection 53
- DC Power Connection 53
- Dry Contact Alarm Connections 54
- Management Connections 54
- Station Clock Connections 54
- LRS-24 with CM-1 Module 55
- LRS-24 with CM-2 Module 56
- Normal Indications 57
- Power Off 57
- Troubleshooting 57
- Chapter 3 59
- Management via the CM-1 59
- 3.2 Hardware Requirements 60
- Supervision 61
- Terminal 61
- Configuring the Terminal 62
- DEF TERM 63
- NODE nn DEF SP 63
- NODE nn DEF PWD 63
- Chapter 4 65
- Management via the CM-2 65
- CM-2 Functions 66
- Introduction 4-3 67
- Management Priorities 68
- Initializing CM-2 69
- 4.2 Hardware Requirements 70
- Terminal Connection Methods 71
- 4-8 Hardware Requirements 72
- Hardware Requirements 4-9 73
- 4-10 Hardware Requirements 74
- Command Language Syntax 75
- Command Protocol 75
- Index of Commands 76
- BY PASS PASS WORD 78
- Chapter 5 81
- Troubleshooting and 81
- Diagnostics 81
- Status/Address 82
- Table 5-2. Error Messages 83
- 5-4 Error Messages 84
- Appendix A 85
- Connector Wiring 85
- A.7 Power Connectors 88
- Appendix B 89
- LRS-PS-FEED Power Supply 89
- B.3 Site Requirements 90
- Front Clearance 91
- Ambient Requirements 91
- Preparation for Installation 92
- Rack Installation 93
- Power Connection 93
- Operation 93
- Appendix C 95
- SNMP Management 95
- MIB Structure 96
- Management Domains Under SNMP 97
- C.3 IP Environment 98
- IP Environment C-5 99
- Net and Subnet Masks 100
- Assignment of Addresses 100
- Default Gateway 100
- C.4 SNMP Traps 101
- C-8 SNMP Traps 102
- Commands 103
- Appendix D 103
- CM-2 Management 103
- Procedure 104
- Command Fields 105
- Order from: Cutter Networks 108
- 1, 2, 3, 4, 6, 8, 10, 15, 20 109
- CM2 Download via LAN 112
- CM2 Download via XMODEM 113
- CM2 Download via CM2 FLASH 113
- Change CM-2 Software Version 113
- View CM-2 Software Version 114
- Modem Download via LAN 116
- Modem Download via XMODEM 116
- Modem Download via CM2 FLASH 116
- Changing Modem Version 118
- D.6 Viewing Modem Version 119
- Purpose 125
- Editing the Configuration 127
- Hub Configuration Operations 128
- Editing a Modem File 129
- Sending Configuration Files 133
- Display Format 136
- D-36 Displaying System Status 138
- Displaying System Status D-37 139
- D.16 Displaying Alarms Log 140
- D.18 Define CM-2 Reset 142
- D.19 Define Password 142
Prodotti e manuali riguardandi Networking RAD Data comm HCD-E1
Networking RAD Data comm MiRICi-E3T3 Specifiche
(106 pagine)
(106 pagine)
Networking RAD Data comm 100 Specifiche
(9 pagine)
(9 pagine)
Networking RAD Data comm ASM-60 Specifiche
(90 pagine)
(90 pagine)
Networking RAD Data comm ASM-10/8 Specifiche
(56 pagine)
(56 pagine)
Networking RAD Data comm ASMi-52CQ Specifiche
(100 pagine)
(100 pagine)
Networking RAD Data comm 146 Manuale Utente
(202 pagine)
(202 pagine)
Networking RAD Data comm LA-210 Specifiche
(210 pagine)
(210 pagine)
Networking RAD Data comm FOMi-T1 Specifiche
(58 pagine)
(58 pagine)
Networking RAD Data comm T1 Specifiche
(158 pagine)
(158 pagine)
Networking RAD Data comm HCD-E1 Specifiche
(232 pagine)
(232 pagine)
Networking RAD Data comm LA-210 Manuale Utente
(158 pagine)
(158 pagine)
Networking RAD Data comm ASMI-450 Manuale Utente
(160 pagine)
(160 pagine)
Networking RAD Data comm FOM-40 Specifiche
(74 pagine)
(74 pagine)
Networking RAD Data comm LRS-24 Specifiche
(76 pagine)
(76 pagine)
Networking RAD Data comm RICi-622GE Specifiche
(184 pagine)
(184 pagine)
Flowserve NRS 1-42 manuali
Manuali dei proprietari e guide per l'utente per Hardware Flowserve NRS 1-42.
We fornisce 2 manuali pdf Flowserve NRS 1-42 per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Flowserve NRS 1-42 Manuale Utente (28 pagine)
Marchio: Flowserve | Categoria: Hardware | Dimensione: 0.84 MB |
Indice
NRS 1-42
1
Contents
2
Installation
10
LED flashes
13
Operation
14
Malfunctions
21
Switching
23
GESTRA GmbH
28
Flowserve NRS 1-42 Manuale Utente (28 pagine)
Marchio: Flowserve | Categoria: Hardware | Dimensione: 0.60 MB |
Indice
NRS 1-42
1
Installation
10
Mode Suite
15
Défaut :
22
Remède :
22
Vitesse de
24
Longueur de
24
Annexe Suite
25
GESTRA GmbH
28
Più prodotti e manuali per Hardware Flowserve
| Modelli | Tipo di Documento |
|---|---|
| NRG 16-42 |
Manuale Utente
Flowserve NRG 16-42 Manuel d'utilisation,
24 pagine
|
| DK 45 |
Manuale Utente
Flowserve DK 45 Benutzerhandbuch,
16 pagine
|
| VKP 10 |
Manuale Utente
Flowserve VKP 10 Benutzerhandbuch,
12 pagine
|
| MK 25/2 |
Manuale Utente
Flowserve MK 25/2 Benutzerhandbuch,
20 pagine
|
| NRS 1.40.1 |
Manuale Utente
Flowserve NRS 1.40.1 Benutzerhandbuch,
34 pagine
|
| BA 46 |
Manuale Utente
Flowserve BA 46 Benutzerhandbuch,
36 pagine
|
| UNA 38 |
Manuale Utente
Flowserve UNA 38 Benutzerhandbuch,
20 pagine
|
| URB 1 |
Manuale Utente
Flowserve URB 1 Manuel d'utilisation,
77 pagine
|
| NRG 16-19 |
Manuale Utente
Flowserve NRG 16-19 Benutzerhandbuch,
20 pagine
|
| TRG 5-11 |
Manuale Utente
Flowserve TRG 5-11 Benutzerhandbuch,
20 pagine
|
| TRV 5-40 |
Manuale Utente
Flowserve TRV 5-40 Benutzerhandbuch,
28 pagine
|
| BK 27N |
Manuale Utente
Flowserve BK 27N Benutzerhandbuch,
16 pagine
|
| URB 2 |
Manuale Utente
Flowserve URB 2 Benutzerhandbuch,
48 pagine
|
| NRG 16-12 |
Manuale Utente
Flowserve NRG 16-12 Benutzerhandbuch,
20 pagine
|
| BK 37 |
Manuale Utente
Flowserve BK 37 Benutzerhandbuch,
16 pagine
|
| NRA 1-3 |
Manuale Utente
Flowserve NRA 1-3 Benutzerhandbuch,
24 pagine
|
| SMK 22 |
Manuale Utente
Flowserve SMK 22 Benutzerhandbuch,
16 pagine
|
| OR 52-7 |
Manuale Utente
Flowserve OR 52-7 Benutzerhandbuch,
40 pagine
|
| UNA 23 |
Manuale Utente
Flowserve UNA 23 Benutzerhandbuch,
24 pagine
|
| NRG 16-38S |
Manuale Utente
Flowserve NRG 16-38S Benutzerhandbuch,
24 pagine
|
© 2020, manymanuals.it. Tutti i diritti riservati | 0.040 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale