RAD Data comm E1 Interface Converter RIC-E1 Specifiche Pagina 18

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
Vedere la pagina 17
Chapter 1 Introduction RIC-E1 Installation and Operation Manual
1-4 Technical Specifications
1.4 Technical Specifications
Link Interface
Coding
HDB3 or AMI
Framing
Unframed
Bit Rate
2.048 Mbps
Impedance
120, balanced
75, unbalanced
RCV Signal Level
0 to -10 dB
XMT Signal Level
3V (±10%), balanced
2.37V (±10%), unbalanced
Connectors
RJ-45, 8-pin, balanced
Two BNC coaxial, unbalanced
Return Loss
Better than 15 dB
DTE Interface
Type
V.35: 34-pin, female
X.21: 15-pin, D-type female
V.36: 37-pin, D-type female, via adapter
cable
RS-530: 25-pin, D-type female
IR-ETH: RJ-45 or BNC
IR-ETH/QN: RJ-45
IR-IP: RJ-45
Control Signals
V.35, X.21, RS-530:
CTS follows RTS
DCD follows E1 state
V.35, RS-530:
DSR is constantly ON
Timing
Derived from three alternative sources:
Internal oscillator
External, from the attached DTE
Receive, derived from the received signal
Indicators
PWR (green)
On – RIC-E1 is powered
TXD (yellow)
On – Data is being transmitted to the link
RXD (yellow)
On – Data is being received from the link
LOS (red)
On – No E1 data is received from the link
TST (red)
On – The local loopback is active
For description of the IR-ETH, IR-ETH/QN and IR-IP interface modules, refer to
Appendix B, Appendix C, and Appendix D, respectively.
Note
Vedere la pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 93 94

Commenti su questo manuale

Nessun commento